In the majority of cases, most people spend quite a lot of money buying their forklift. Therefore, it is extremely important to take proper care of it in order to protect your investment well into the long run. It is a great idea to know the procedures which are undertaken during the maintenance and care of this piece of machinery.
By starting up the forklift and listening closely how it works is amongst the best ways to tell how good the engine is running. Like for example, if there are any knocks or misses, the equipment is faulty and this should raise some concerns. Also listen carefully for any squealing sounds which come from the belts since these sounds will provide you with a wealth of information.
When doing maintenance, some of the main parts you would have to pay attention to comprise the safety warning devices, horn, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also vital to inspect the wiring.
After the above parts have been checked carefully, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Each and every cell of the battery should be inspected so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The transmission filter, fuel filters and the hydraulic filter need to be replaced regularly. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been completed and new filters have been fitted, visually check the drive axle from beneath the machinery. Be certain to grease the axle if there is any grease fitting. Inspect the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Then, check each and every other part of the equipment including the wheels. If any kind of problem or fault is detected, be certain to deal with it immediately so as to make sure the machine is running at its safest and optimum levels.